So what's the latest?

nearly done.

was on the rolling road today. I wasn't there so no pics...

they're replacing the accelerator cable for a better one in the morning and it needs a hex stud between the bottom of the connecting rod and the carb.(brings out the connecting rod inline with the linkage arm).

all should be done then.

will get all the readings when I collect the van.(only up to 4000rpm)

got to do at least another 1500miles on the engine, then back in for final tune and power runs

Oil Breather pics:

left rocker cover:


right rocker cover:


breather hose going through the tinwear right side (had to drill a hole on the left side by the brake vacuum line)


positioning of the breather box on firewall and hoses conected from rockers and crackcase breather fitted.


pic from above through access hatch.

Looking good......

forgot to mention ....the outlets are smooth and quite short ....where the hose goes on to the rocker covers ......if you buy two bolts with the same thread as the suppied nuts .....I can turn them down on the lathe and you can cut them to whatever length you feel if safe .

I pushed the hose over the thread and them did up the clamps.

will keep a close eye on it for a while.

you can take a look at them if you want. always nice to have another pair of eyes to see if I made any obvious mistakes.

they look fine dude ....it was an observation I had when doing the ghia 's engine .....I could pull them off ....so I made longer outlets ....it may have been cos of the angle of the hose ....you probably have more space in your engine bay

least we didnt mount it the other way up 90 degree turn hey lol ! u added the tie wrap round the fuel line good stuff, talking of fuel line did we check that bit of line coming of the fuel tank bud , wasent it spinning ? , i cant remeber seeing you do that,

yep, just tightened up the clip. it was well over the barb on the tank: approx 3/4" into the hose. will prob replace it and put a new inline filter in when i next drain the tank......













in a couple of days then....

kool kool

Still got the engine noise. So going to Interpro..

hopefully nothing serious...

if it is, then engine out and back to TES along with a refund demand!!

I reckon I've spent double the value of the engine on the engine!!


So then I my look for some alternative power

Anyhow,

been having an odd suspension noise for a bit.

sorted it today, shock to tower bolt was loose arrgghh!

what engine noise have you got?

Engine noise is a kinda tapping/knocking in time with the revolutions. (Speeds up and slows down).

May be rockers.... or fan catching the housing slightly... or something else....?

Tis louder when engine is first started up from cold...

I get similar on the frid engine ....only on tickover .....it turns out its got either a worn cam or followers....actually my noise comes and goes

Dropped off van at Interpro today.

Being tuned on Monday.

Took 2hrs to get there mind, stupid bridge road works.

Also, the front rattle had returned..

Shock top bolt had worked loose again. cleaned it, put on a washer and spring washer to help keep the nut tight.

AND....


front hub had some sideways movement.... so adjusted the clamp nut on the spindle by 1/4 turn, all fixed!